best selleing product
KONG ORIGINAL Impact...
₦16,000.00
Electrical Insulating...
₦559,000.00
Electrical Insulating...
₦881,500.00
Motorola GP340 ATEX Two-Way...
₦1,080,375.00
3M Peltor Optime 98 Ear Muff
₦16,000.00
APS High Voltage Holiday Detector
The Tinker-Rasor low voltage holiday detector verifies a pinhole-free coating using the low voltage wet sponge holiday detector. Tinker-Rasor is a leader in holiday detection equipment. The portable, plastic solid state transitorized nondestructive low voltage (67.5v) detector uses regular potable water from a wetted sponge and a ground wire (attached to the uncoated substrate) to complete a circuit and produce an audible signal indicating a pinhole or flaw in the coating. A red indicator light also illuminates when the detector alarms. The tester is suitable for use on any nonconductive coating (up to 20 mils thick) applied to a conductive substrate. While there is no spark hazard during detection, the device operates on batteries and is not intrinsically safe.
Model: APS High Voltage Holiday Detector “Stick Type”
800 volts to 35,000 volts in 1 instrument
Features
- 800 volts to 35,000 volts in one instrument
- Safety cutoff switch
- Digital output display
- Super bright LED display
- Two volume Settings
- Regulated voltage
- Large push button controls
- Greater battery efficiency
- Compatible with Model AP/S1 & AP/S2 components and accessories
- Open, ergonomic design
- THREE YEAR WARRANTY
The Model APS comes complete in kit form, including:
- APS instrument and two batteries
- Battery Charger
- Ground cable, 20'
- Wand handle, 18", with full circle spring electrode connector
- Compax Connector for full circle electrodes
- 4" Rubber paddle electrode
- Voltage adjusting screwdriver
- Adapter to use "Spy" Spring Electrodes
- Mil-SPEC, carrying case
- One electrodeInstructions Manual
- Certificate of Calibration
000375
chat
Comments (0)
16 other products in the same category:
The Tinker-Rasor low voltage holiday detector verifies a pinhole-free coating using the low voltage wet sponge holiday detector. Tinker-Rasor is a leader in holiday detection equipment. The portable, plastic solid state transitorized nondestructive low voltage (67.5v) detector uses regular potable water from a wetted sponge and a ground wire (attached to the uncoated substrate) to complete a circuit and produce an audible signal indicating a pinhole or flaw in the coating. A red indicator light also illuminates when the detector alarms. The tester is suitable for use on any nonconductive coating (up to 20 mils thick) applied to a conductive substrate. While there is no spark hazard during detection, the device operates on batteries and is not intrinsically safe.
